
C546 Elliptical Fitness Crosstrainerl
Page 29
21. Using your finger, press in on the center of the lower span of the input belt. Compare the
pressure required to deflect the input belt to the pressure required to deflect the step up belt.
Diagram 5.6 - Stub Tensioner
22. Loosen the stub tensioner axle nut slightly. Turn the stub tensioner adjustment bolt
clockwise to increase or counterclockwise to decrease the input belt tension.
23. When the input belt tension is correct, torque the stub tensioner nut to 200 in/lbs. Replace
the stairarms per Procedure 7.24.
24. Check the operation of the unit as described in Section Four, then re-install the rear cover
as described in Procedure 7.1
Stub
Tensioner
Stub Tensioner
Axle Nut
Stub Tensioner
Adjustment Bolt
Comentarios a estos manuales