Precor EFX546 Manual de servicio descargar pdf (Pagina 70)

C546 Elliptical Fitness Crosstrainer

Page 70

37. Carefully, rotate the center handrail mounting tube back into it’s mounting position.

38. Set the two halves of the clamp in position, be sure that the pins in the rear half of the clamp

mate with the holes in the frame, thread and hand tighten the four clamp mounting screws.

Tighten the upper clamp mounting screws before the lower clamp mounting screws. (See

Diagram 7.24)

39. Tighten the upper handrail clamp mounting screws.

40. Check operation of the EFX as described in Section Four.

Replacing the Lower interconnect Cable.

41. Remove the rear cover. Remove the shield from the lower PCA.

42. Tape the replacement interconnect cable to the upper end of the existing lower interconnect

cable.

43. Carefully, pull the interconnect cable out of the access hole near the lower PCA.

44. Remove the tape and discard the old lower interconnect cable.

45. Connect the lower interconnect cable to the lower PCA. Replace the lower PCA shield.

Replace the rear cover.

46. Using the mid-point connector removed in step 31, connect the upper interconnect cable to

the lower interconnect cable.

47. Carefully, rotate the center handrail mounting tube back into it’s mounting position.

48. Set the two halves of the clamp in position, be sure that the pins in the rear half of the clamp

mate with the holes in the frame, thread and hand tighten the four clamp mounting screws.

Tighten the upper clamp mounting screws before the lower clamp mounting screws. (See

Diagram 7.24)

49. Tighten the upper handrail clamp mounting screws.

50. Check operation of the EFX as described in Section Four.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 117 118

Sin comentarios

Precor EFX546 Manual de servicio Pagina 70